Why do my lights flicker in Barking? +
Occasional flickering is usually caused by a loose bulb or a poor connection at the light fitting. Persistent flickering across multiple lights can indicate a loose neutral connection at the consumer unit, a faulty main switch, or an issue with the incoming supply. If all lights in your home flicker simultaneously, this could be a supply-side issue — contact your DNO first. Otherwise, have an electrician in Barking check the connections at your consumer unit.
Can I do any electrical work myself? +
You can legally carry out minor electrical work such as replacing light switches, sockets (like-for-like), and light fittings without notifying building control. However, you must not add new circuits, work in bathrooms or kitchens (within zones), replace a consumer unit, or install outdoor wiring unless you are Part P registered. DIY electrical work is a leading cause of house fires — if you are unsure, always call a qualified electrician in Barking.
Is a tripping circuit breaker dangerous? +
A circuit breaker that trips occasionally is doing its job — protecting you from overcurrent. However, frequent or immediate tripping indicates an underlying fault such as a short circuit, overloaded ring main, or deteriorated cable insulation. Do not simply keep resetting it, as this bypasses the protection that is keeping you safe. Have an electrician in Barking diagnose the cause before using the circuit again.
What should I do if I have a complete power cut in Barking? +
First, check whether your neighbours also have no power — if so, it is likely a supply fault and you should call your local distribution network operator (DNO), not an electrician. If it is only your property, check your consumer unit for tripped switches. If the main switch will not stay on, or keeps tripping immediately, do not keep resetting it — call an emergency electrician in Barking as there may be a serious fault on one of your circuits.
What is the difference between an RCD and an MCB? +
An MCB (Miniature Circuit Breaker) protects against overcurrent and short circuits — it is the modern equivalent of a fuse. An RCD (Residual Current Device) protects against earth leakage, which is what can kill you if you touch a live wire. Modern consumer units use RCBOs, which combine both functions into a single device per circuit, giving you the best protection. If your consumer unit still has rewirable fuses, it is overdue for an upgrade.
What is Part P and why does it matter? +
Part P of the Building Regulations covers electrical safety in dwellings. Certain types of electrical work — including new circuits, consumer unit replacements, and work in bathrooms or kitchens — are classed as notifiable and must either be carried out by a Part P registered electrician or inspected by building control. Using a registered electrician saves you the building control fee (typically £200–£300) and ensures the work is properly certified.